Toybrain further improvements

Posted in Arduino, Making, ToyBrain - January 15, 2013 - 0 Comment

I populated one of the Toybrain V2 boards and gave it a bit of a shakedown. I still have to test the motor driver, but I’ve at least fixed the backwards ICSP header and the reversed TX/RX lines. I did add a LED for debugging, but then hooked it up to a ADC line, so lighting it up means losing an analog pin.

For those as don’t know, you can get the analog pins on an Arduino/ATMega168/ATMega328/whatever to act as a digital GPIO by treating it like one, using the aliases “A0” through “A5”. Full instructions are here.

The V2 boards also have a reset button, which is very useful.

I’m already working on V3, which is going to be smaller. The V2 has headers for power, ground, and data for each pin, which I think is a bit much. I want that room back to build a voltage regulator and some filtering onto the board. The microcontroller can run at 1.8 to 5.5 volts, so the filtering is a bit more important than the regulation. However, some toys surely run at 6 volts or more, and would ruin the microcontroller, which is a SMD device.

So V3 will include filter capacitors, probably SMD, on the power rails, and a 3.3V regulator (The Micrel MIC5209-3.3 in SOT233 package looks good) or the option to short around it. The regulator only supplies the power for the microcontroller, so it won’t need to be very high power.