Mindflex EEG Hacking
I got a Mindflex Duel for Christmas. The Mindflex Duel is a toy that uses a pair of EEG headsets to read signals from the users, and then send those signals to a base unit that contains a blower and a little sliding cart to move the blower. The users try to concentrate to control the cart, moving a little ball suspended in the air jet from the blower into a goal.
Needless to say, I gutted it.
The base unit has a little PCB with a 2.4Ghz radio on it, and a little hardware to control the blower and cart motors. The headsets are the really interesting part. Each one has a single-channel EEG and a wireless radio. I took the radios out and replaced them with BlueSmiRF bluetooth-to-serial links so that I could connect them to my laptop. The hardware part of the replacement is below, the software part will be in another post.
The guts of one of the headsets. The 2.4 Ghz radio is the top daughter board, the EEG hardware is the bottom daughter board.
I desoldered the original radio. It works in the same band as Bluetooth, and consumes power, so there was no need to have it there.
The red and black wires supply power for the BlueSmiRF. It can take up to 5 or so volts, but the headset runs on 4.5v, so it is fine to hook it up like this. The red wire is connected to the power switch, rather than V+, so that the power switch also turns off the bluetooth radio.
The white wire goes from the pin labeled “T” on the EEG board to the RX pin on the BlueSmiRF. The T pin of the EEG board is a serial line, which transmits the EEG data to the BlueSmiRF.
Glue the bluetooth radio into place with hot glue. The LEDs on the BlueSmiRF are covered by black paint on the inside of the Mindflex headset, but I scractched away the paint in little circles so the BlueSmiRF status lights would shine through.
The finished product looks stock, until you turn it on. That red light on the side is not normally there.
Recent Comments