Gizmosmith

A Word of Warning

My PhD work (TinyRobo) uses a USB-Serial converter to talk to the ESP-8266 modules in the tiny robots. Normal FTDI cables have a cable that ends in a 0.1″ 6-pin header with this pinout:

1. Black – Ground
2. Brown – CTS
3. Red – VCC
4. Orange – TX
5. Yellow – RX
6. Green – RTS

It turns out that esptool can manipulate the DTR and RTS lines to reset the chip in bootloader mode, which is great for uploading code to it. It also means I can get away with not having any parts on the TinyRobo boards to handle the reset, which is great because it lets me keep the board small. Unfortunately, the FTDI cable I have doesn’t expose the RTS line, so I got a converter module for cheap off Amazon. The particular module I got is this one:

I added that red wire and cut a trace so that the pins would be:

1. DTR
2. RX
3. TX
4. VCC
5. CTS
6. Ground

So far, so good, but I can’t upload with it. I threw a scope on the lines, and it looks like instead of swinging from VCC to ground like well-behaved TTL serial lines, they swing from VCC to VCC minus some tiny voltage, less than a volt. Adding pull-downs on the lines doesn’t seem to have helped. It could be that the timing is of, but I suspect that somewhere, some cheapskate saved some fraction of a cent on this board, at the expense of it doing the one thing it was supposed to do (YOU HAD ONE JOB).